Model No: DMI-1 with Dosage 0.01 cc, 0.03 cc, 0.05 cc, 0.10 cc, 0.16 cc Per Stroke
Model No: DMI-2 With Dosage 0.25 cc, 0.40 cc Per Stroke.
Model No: DMI-3 With Dosage 1.00 cc, 1.60 Per Stroke
Note: Above metering injectors are available in M.S. as well as brass with honed bore Nitrile rubber parts & accurate dosage.

Model No: DM-1 One Way ( for Single Injector)
Model No: DM-2 Two Way ( for two Injectors)
Model No: DM-3 Three Way ( for three Injectors)
Model No: DM-4 Four Way ( for four Injectors)
Model No: DM-5 Five Way ( for five Injectors)
Model No: DM-6 Six Way ( for six Injectors)
Model No: DM-7 Seven Way ( for seven Injectors)
Model No: DM-8 Eight Way ( for eight Injectors)
Model No: DM-9 Nine Way ( for nine Injectors)
Model No: DM-10 Ten Way ( for ten injectors)

Model No: DMT-002 (No. of outlets-2).
Model No: DMT-003 (No. of outlets-3)
Model No: DMT-004 (No. of outlets-4)
The Take OFF metering injectors are made of zinc (pressure die casting) material.
The Take OFF metering injectors works on a different principle unlike the normal metering injectors which discharges the oil when pump is ON. In this case when the pump is ON the TAKE OFF injectors are charged and the spring loaded piston ejects (Pin) out thereby indicating TAKE OFF injectors are charged. When the pump stops the oil is flushed out from the injectors to the lubricating points and the piston goes back. A non return valve in each injectors does not allow oil to go back.

Dropco developed a special heavy duty and preceise grease injector to meetindustries need for proper lubrication.